User`s manual

23
 Battery open status check: If enabled, the monitored UPS will check if the
battery connection ok or not when UPS is turned on.
 Cold start: If disabled, the UPS can be turned on only when AC is normally
connected to UPS. Vice versa.
 Bypass not allowed: I f e n a b l e d , t h e U P S w i l l n o t t r a n s f e r t o b y p a s s m o d e u n d er
any conditions. I f d i s a b l e d , t h e U P S w i l l b e a l l o w e d t o t r a n s f e r t o b y p a s s m o d e
according to UPS internal setting.
 Battery deep-discharge protection: If enabled, t he m on it or ed U P S s h ut do wn in
accordance with the condition of battery and load on battery mode to protect
battery. Vice versa.
 Site fault detection: If enabled, the monitored UPS will beep when the input
neutral and hot wires are reversed. Vice versa.
 P1 Programmable outlet control (battery mode): If enabled, when UPS is
running at battery mo d e , i t will cut off P1 outlets after backup setting time arrive.
If disabled, UPS will provide continuous power to P1 outlets until the battery is
running out.
 O u t l e t s e t t i n g : U s e r s c a n s e t l i m i t e d b a c k u p t i m e f o r P 1 o u t l e t s w h e n U P S i s o n
battery mode.
 Battery numbers setting:
 Numbers in parallel: set battery numbers in parallel.
 Voltage and frequency range for bypass mode: Set acceptable voltage and
frequency range in bypass mode.
 M a x i m u m a n d m i n i m u m v o l t a g e : W h e n U P S i s o n b y p a s s m o d e a n d i n p u t
voltage is out of setting range, UPS will enter battery mode.
 Maximum and minimum frequency: When UPS is on bypass mode and
input frequency is out of setting range, UPS will enter battery mode.
 Voltage range for ECO mode: Set acceptable voltage range for ECO mode.
4.2.4. Purchasing Information
Users can enter UPS purchasing date, battery purchasing date, UPS warranty time, and
battery warranty time.
Step 1 Select UPS Setting >> Purchasing Information. Refer to Diagram 4-11.