User`s manual

26
Step 2 Set frequency and setting time on the right column.
NOTE: Rules for setting time.
Daily schedule – P ow e r-off time should be earlier than power-on time. It only
applies to set power-on time and power-off time within the same day.
Weekly schedule –Po w e r -off time should be earlier than power-on time. It only
applies to set power-on time and power-off time within the same week.
S t e p 3 : C l i c k “ A d d ” t o a dd task. If task is successfully set, it will display on the task
ta ble o n th e le ft-hand side. Select specific task and click “Delete” button to delete
the task.
4.3.3. Scheduled Battery Self-Test
Scheduled battery self-test can be executed once, daily, weekly, or monthly. In the
window of “Scheduled Battery Self-Te st S et ti n g” , u se rs c an c ho ose t im e p a ra me te rs . I t
i s r e c o m m e n d e d t o s e t o n l y o n e a c t i o n i n t h e s a m e t i m e . I f m u l t i p l e a c t i o n s h a v e b e e n
specified at the same time, some of these actions may be ignored. Any actions which
are not supported by the UPS will be ignored.
Step 1 Select Control >> Battery Self-Test. Refer to Diagram 4-14.
Diagram 4-14
Step 2 Select method and time parameters.
There are three self-test methods:
 10-second self-test: Battery will discharge for 10 seconds.
 Self-test: Users can set battery discharge time for self-test.
 Deep test: This test will let battery discharge until it’s in low battery level.