Instructions / Assembly

8
Installing the Glass Housing
Figure 13
Scroll Ring
Set Screws
Scroll Arms
Screws
Screws
Screws
Glass Housing
Motor Housing
Bulbs
Remove 1 of the 4 screws from the bottom of
the motor housing and loosen the other 3
screws. (Do not remove)
Raise and hold the glass housing close to the
motor, place the key holes on the glass housing
over the 3 screws previously loosened from the
motor housing, turn glass housing until it locks
in place at the narrow section of the key holes.
Secure by tightening the 3 screws previously
loosened and the one previously removed.
(Fig. 13)
Remove the screw located on the top of glass
housing, place the decorative scroll arm on to
the top of the glass housing and secure with the
screw removed previously. Repeat for other
decorative scroll arms. (Fig. 13)
Tighten the 4 screws on the scroll ring, be sure
to secure the decorative scroll arm to scroll ring
tightly. Tighten two set screws on scroll ring
firmly. (Fig. 13)
Install the 6 x 15W bulbs (provided) into the
sockets of the bulb holder assembly. (Fig. 13)
1.
2.
3.
4.
5.
WARNING
MAKE SURE THE TAB ON THE HANGING
BRACKET PROPERLY SITS IN THE GROOVE
IN THE HANGER BALL BEFORE ATTACH-
ING THE CANOPY TO THE BRACKET BY
TURNING THE HOUSING UNTIL IT DROPS
INTO PLACE.
Figure 12
Outlet Box
Ceiling
Mounting
Bracket
Screw
Screw
Canopy
Canopy
Bottom Cover