Instructions / Assembly

10
Installing the Switch
Housing
Remove the 1 of 3 screws from the mounting
ring and loosen the other 2 screws. (Do not
remove)
While holding the switch housing under your
fan, snap together the wire connection plugs.
Carefully push all wires back into the switch
housing. Place the key holes on the switch
housing over the 2 screws previously loosened
from the mounting ring, turn switch housing
until it locks in place at the narrow section of
the key holes. Secure by tightening the 2
screws previously loosened and the one
previously removed. (Fig. 16)
1.
2.
3.
Mounting Ring
Switch Housing
Screws
Wire
Connection
Plugs
Figure 16