Instructions / Assembly

10
Installing the Light Kit
CAUTION
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
While holding the light kit under your fan,
locate two single white and blue wires in the
switch housing labeled "FOR LIGHT". Make
the polarized plug connections:
- White to white
- Blue to black
Carefully push all wires back into the switch
housing. Attach the light kit fitter by aligning
its keyhole slots with the three screw holes and
the reverse switch on the switch housing.
Tighten the three screws securely to prevent
the light kit from vibrating loose. (Fig. 15)
Install 2 x 13 Watt GU24 compact fluorescent
bulbs (included). NOTE: CFL bulbs are NOT
dimmable.
Remove the metal nut, glass cap and decorative
nut from the light kit. Place glass shade over
the light kit stem, secure with the metal nut
(rubber side on the top), glass cap and decora-
tive nut. DO NOT OVER TIGHTEN. (Fig. 16)
1.
2.
3.
4.
5.
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
Figure 15
Figure 16
Bulbs
Pull Chains
Glass Shade
Light Kit
Assembly
Glass Cap
Metal Nut
Decorative Nut
Switch
Housing
Screws
Light Kit Aassembly
Wire Connection
Plugs
Restore power and your light kit is ready for
operation.