Use and Care Manual

8
Attaching the Fan Blades
CAUTION
MOTOR IS SHIPPED WITH MOTOR SUPPORT
PLATE PREVENT MOVEMENT DURING TRANS-
PORTATION. REMOVE THE SCREWS FROM
THE MOTOR SUPPORT PLATE, DISCARD THE
MOTOR SUPPORT PLATE. (FIG. 13)
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE ARMS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NO INSERT FOREIGN
OBJECTS BETWEEN ROTATING FAN BLADES.
Figure 13
Screws
Motor Support Plate
Figure 14
Blade
Screws with
Rubber Washers
Blade Arm
Blade Arm
Medallion
Motor
Blade Arm
Tab
Slot
Figure 15
Attach the blades to the blade arms using the
screws with rubber washers provided (Fig. 14).
Start a screw into the blade arm, do not tighten.
Repeat for the 2 remaining screws and
washers.
Tighten each screw securely starting with the
center screw. Make sure the blade is straight.
Repeat steps for the remaining blades.
Fasten the blade assemblies to the motor
housing by lining up the slots of the blade arms
with the tabs on the motor housing, then
tighten the two screws and washers already
installed in the blade arms (Figure 15).
1.
2.
3.