Use and Care Manual

10
Installing the
Light Kit.
Remove the plug from the switch housing
cover.(Fig. 18) Attach the light kit to the switch
housing cover by feeding the light kit wires
(black and white) through the hole of switch
housing cover and then screw it onto the switch
housing cover by nut & lock washer. Be sure it
is tight enough to prevent light kit from vibrat-
ing loose. (Fig. 18)
While holding the light kit assembly under
your fan, Make the polarized plug connections:
(Figure 19)
- White to white
- Blue to black
Carefully push all wires back into the switch
housing, then install the light kit assembly onto
the mounting plate with 3 screws provided. Be
sure to tighten all screws. (Fig. 19)
1.
2.
3.
Remove the lock ring from the socket by turning
the lock ring clockwise Until it unlocks. Insert
the glass into the glass holder and turn the lock
ring counter-clockwise to tighten the glass.
Repeat for the remaining glass. (Fig. 19)
Install 4 x 13 Watt compact fluorescent bulbs
(included). NOTE: CFL bulbs are NOT
dimmable.
Restore power and your light kit is ready for
operation.
4.
5.
6.
Figure 18
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
Switch Housing
Cover
Light Kit
Nut
Lock Washer
Plug
Figure 19
Screws
Bulbs
Light Kit
Assembly
Glass Shade
Wire Connection
Plugs
Lock Ring
CAUTION
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.