Instruction Manual

STEP FOUR: START UP
Turn on air handler and inflate diffuser. With the diffuser inflated, anchor the last glider of the diffuser near to the rail
by drilling a set screw before it as shown. This will keep the diffuser fully extended when diffuser is deflated and keep
the diffuser from sliding back.
If the diffuser system flutters after installation, check to see if air handler is operating at its designed air volume and
static pressure. Fluttering can cause damage to fabric shortening life of system.
WARRANTY INFORMATION
Diffuser systems are subject to a five year limited warranty. The warranty covers workmanship and materials
on all components of the system. Only replacement costs and credits are covered. Cash payments are not
available. The warranty covers freight costs, but does not cover installation costs. The warranty excludes dam-
age caused by improper installation, failure to specify all system requirements and air handling equipment not
performing as specified.
The effective start date of the warranty is the product ship date.
STEP THREE: INSTALLATION OF FABRIC DIFFUSER
When handling a diffuser prior and during installation, please keep anything that comes in contact with the diffuser
clean. If a diffuser is to be laid out on the floor, make sure floor is clean or something is laid down to protect diffuser
from dirt or debris on the ground that could catch on air jets and damage diffuser during installation.
1.) Slide the gliders down through the rail.
2.) Pull diffuser down the rail until fully extended.
3.) Pull open end of diffuser and slip over metal collar or metal duct (about 6-12”).
4.) install worm gear band around diffuser to secure it to metal duct.
Note: Worm gear bands are perforated and self taping screws can be used to help secure band and
keep from slipping. ( screws not included).