User Guide

ManualsBrandsAir Gap ManualsDrainsQuick Connect Reverse Osmosis Drain Line Adapter w/ 3/8" Push-In Inlet (Commercial)

Old Part Number:

ET112-002

Optional ( Horizontal Installation)

2. Slip S.J. nut and beveled waster

over both ends of the cut tube, then

insert the 3-way repair tee in the

following manner: Loosen

the S.J. nut on the horizontal waste

ell where it joins the vertical

tailpiece. (See Fig. 8) Remove the

short “ell” piece by pulling down the

tailpiece, then put cut ends of ell

into a tee and tilt vertical end back

up over tailpiece and re-secure S.J.

nut. Rotate tee so that the side

outlet is facing straight up, then

firmly tighten both S.J. nuts to tee.

(See Fig. 9)

CONFIGURATION – B

For best results, use Configuration – A only

Serving the

Reverse Osmosis

Water Treatment Industry

Pat. No. 5,449,456

Pat. No. 5,681,459

Pat. No. 5,944,985

Pat. No. 6,193,879

MADE IN USA

For Multi Compartment

-OR-

Single Compartment Sink

without Disposal

CONFIGURATION – C

1. Measure the midpoint on the horizontal waste

ell and cut out 1 ½” of tubing. (See Fig. 7)

OPTIONAL: To further decrease or eliminate reject water noise, rotate

side outlet for a tee from vertical down to 45°

3. Follow instructions 5 & 6 (configuration – A) to complete installation.

For best results: Do not

Install an ET112-002 on the

horizontal pipe coming

straight out of the disposal

(See Fig. 10). If the vertical

tailpiece is too short, use an

ET116-002.

CAUTION: Be careful not to

“over-tighten” any screw on

plastic fittings.

To connect reverse osmosis reject water

drain line to the plumbing of a single

compartment sink with disposal, please

request an ET109-002 or ET116-002.

The ET112-002 is designed to be used

downstream of an approved air gap.

NOTE:

Cut

1 ½"

FIG. 8

FIG. 9

FIG. 10

FIG. 7

ASTM F 409

12-38QC

DLA-12

Doc. # 400-0718-004

MADE IN USA

ASTM F 409

(Not Recommended)

REVERSE OSMOSIS

DRAIN LINE ADAPTER

Placentia, California

Model:

500 Jefferson Street, Placentia, California 92870 USA • 949-955-3928 • Email: orders@airgap.com

Summary of content (2 pages)

PAGE 1
Placentia, California CONFIGURATION – B Optional ( Horizontal Installation) For best results, use Configuration – A only Cut 1 ½" 1. Measure the midpoint on the horizontal waste ell and cut out 1 ½” of tubing. (See Fig. 7) 2. Slip S.J. nut and beveled waster over both ends of the cut tube, then insert the 3-way repair tee in the following manner: Loosen the S.J. nut on the horizontal waste ell where it joins the vertical tailpiece. (See Fig.
PAGE 2
ET112-002 Installation Procedures For Multi Compartment Sinks or Single Compartment Sink without Disposal LIST OF PARTS ENCLOSED 1 – Drain Line Adapter with Push-In Connection (ET109-002/ET112-002)... 1 – 3-Way Repair Tee 3 – Slip Joint (S.J.) Wing Nuts 3 – Slip Joint (S.J.) Beveled Washers •The ET112-002 provides an IAPMO / UPC listed alternative to the use of the drain saddle, which is a prohibited fitting in the United States.