Use and Care Manual

Filling The Water Tank
CAUTION: Always unplug the unit before removing the Water Tank. Do not touch the water in the base.
NOTE: Never ll the water tank from the top of the unit. Follow Water Tank lling instructions in #4.
Remove Extension Nozzle and
Dual Directional Mist Nozzle
prior to lling the water tank.
Attach Ceramic lter
(included) to the Tank
Cap by aligning the lock
tabs on both and turning
the cap counterclockwise
to lock. When attached
properly the Filter will not
fall from the Tank Cap.
Replace the Tank Cap by
rmly turning clockwise until
tight. Turn the Water Tank
upright and check the Tank
Cap for leaks. If any water
drips, remove the Tank
Cap and retighten. Do not
place Water Tank on the
Humidier Base if the cap
is leaking.
Lift the handle up and replace
on the Humidier Base, make
sure to follow the shape of the
Water Tank and the Humidier
Base (as shown to the left) so
that the tank sits level and ush
to the base. Ensure the tank is
rmly seated.
Attach the Dual Directional
Mist Nozzle or Extension
Nozzle & Dual Directional Mist
Nozzle together to the top of
the Humidier Tank for desired
use as pictured.
Lift the handle on top of the
Water to remove the Humidier
from the base.
Make sure the handle is
snapped back into place, then
turn the Water Tank upside
down and remove the Tank Cap
by turning it counter clockwise.
Fill the Water Tank with clean,
cool tap water. Do not use
extremely cold water, since it
may temporarily reduce the
mist output. Never ll with
hot/warm water or add ad-
ditives as this could damage
the unit and void the warranty.
1
2
3
4
4
5
6
8
7