Instructions / Assembly
Operating Instructions
WARNING: DO NOT operate the humidier without water in the water bottle.
WARNING: NEVER lift the water bottle OFF the Base while the unit is operating.
NOTE: Do not operate the humidier without a full water bottle attached.
1. ON/OFF/Mist Output - Plug into a standard (110V) electrical outlet with the supplied
Power Adaptor. Press the Power Button once to turn ON. Mist output will be on HIGH;
press the Power Button a second time to change the mist output to LOW. To turn OFF,
press the Power Button a third time. Mist may not appear immediately; allow up to 15
minutes for the water in the water bottle to transfer to the Base.
2. UV Light – The UV Light function automatically comes on when the unit is turned ON.
To deactivate, depress the Power Button for 3 - 5 seconds.
3. Low Water – When the Water Reservoir is out of water the automatic safety shut-o will
turn the Ultrasonic Nebulizer OFF. You may hear the fan for a few seconds, this is normal.
Storage
1. Follow all cleaning instructions prior to storage.
2. Dry all parts, including the inside of the Base.
WARNING: NEVER
leave water inside
the Base for several days.
3. To prolong the life of the Water Bottle Adaptor, do not store inside of a water bottle.
4. Preferably store in its original box, in a dry place away from high temperatures.
5. Follow all cleaning instructions after long periods of storage.
5
About White Dust
Use of high-mineral content water may cause a white mineral residue to accumulate on room
surfaces near the humidier. The mineral residue is commonly referred to as “White Dust”. The
higher the mineral content (the harder your water is), the greater the potential for White Dust.
The White Dust is not caused by a defect in the humidier, but is due only to minerals
suspended in the water from your tap.
WARNING:
If you have hard tap water STOP using
tap water and use ONLY ltered, distilled, cold boiled or bottled water to minimize the White
Dust residue.