Instruction manual

4
PREPARING THE TOOL FOR SERVICE
1
1
1
.
.
.
Inspect for damage
2
2
2
.
.
.
Connect the tool to the air supply
3
3
3
.
.
.
Choose and securely install the applicable nose piece for the rivets you wish to apply.
4
4
4
.
.
.
Adjust the vacuum until rivet is held in the nose piece while tool is pointed downward.
a. Adjust vacuum by rotating the small brass valve located at reat of the tool inside the
mandrel catcher using the wrench provided.
5
5
5
.
.
.
Bring the tool and the rivet into the application hole. Insure the rivet head flat onto surface
6
6
6
.
.
.
Fully Actuate the trigger. The tool will cycle and set the rivet while ejecting the nail into the
rear mandrel catcher.
7
7
7
.
.
.
Empty catcher when at 50% capacity