Instruction manual
6
A
IR SUPPLY
• The rivet tool is powered by compressed air at an optimum pressure of 5.5 bar (80 psi)
• The use of a pressure regulator filter/lubricator unit within 3 meters of the tool is highly
recommended to extend the life of the tool.
Dirt and/or water in the air supply can seriously impact the performance and durability of
the tool; damage to the tool caused by contaminated air supply is not covered under
warranty
MAINTENANCE
In order to maintain the tool in a safe working order it is important to carry out regular maintenance
as prescribed by the manufacturer. A thorough inspection replacement of all seals within the tool
should be carried out after 500,000 placings or annually, whichever is the sooner. Item numbers in
parentheses refer to assembly drawing part numbers
Daily
Check for air leaks. Any damaged hoses should be replaced
Lubricate the tool by pouring a 1 drop of light lubricating oil into the air inlet on the tool
If there is no pressure regulator, bleed the airline to clear it of accumulated dirt or water
before connecting the air hose to the tool. If there is a filter, drain it.
Check for proper nose piece use depending on the size of the rivet.
Remove front jaw nose assembly and inspect for cracks or other damage to front and rear of
the nose piece. Replace if necessary.
Insure that rotary valve for the vaccum on the mandrel collection unit is correctly adjusted
for fastener retention
Weekly
Carry out procedures as per daily maintenance instructions above
Clean and inspect the jaws for signs of damage or wear (groove running through the jaw
serrations). Follow the instructions on page 4 for cleaning of jaws. Reassemble the tail jaws
with a light coating of grease on the outer face that contacts the jaw housing. Do not allow
grease to contaminate the grooved inner face of the jaws as mandrel slippage may result.
Monthly
Carry out procedures as per daily maintenance instructions above
Check and replace cylinder bodies if there are signs of damage or cracks.