Troubleshooting guide

3. Reinstall the light reflector by securing in place on the mounting
bolt with the flat washer then the reflector, two lock washers
and reflector nut. Tighten nut fully (Figure 12).
CAUTION: FAILURE TO SECURE THE REFLECTOR BOLT MAY
RESULT IN A RATTLING OR HUMMING NOISE.
4. Install the appropriate bulbs (not included) specific to your model:
AK863L: Install a 100 watt maximum, type A19 medium base
incandescent bulb (not included) and a 7 watt maximum
type C7 (candelabra base) night light (not included).
AK863FL: Install a 26 watt maximum, 2 pin quad, G24-d3
fluorescent lamp (not included) and a 7 watt maximum
type C7 (candelabra base) night light (not included).
Sylvania model: CF26DD/841
GE model: F26DBXT4/SPX41
Phillips model: PL-C 26W/41/ALTO
CAUTION: WHEN INSTALLING GRILL, BE CAREFUL NOT
TO PINCH FINGERS BETWEEN GRILL AND CEILING.
5. Install the grill by squeezing the two ends of the springs
together and installing them up into the slots on the fan’s
housing. Push the grill up into position (Figure 13).
6. Restore power and test your installation.
www.airkinglimited.com
211572097 Rev. A 8-05 4 of 12
SECTION 7
Use and Care
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE SERVICING THE UNIT.
1. Cleaning the Grill: Remove grill and use a mild detergent,
such as dishwashing liquid, and dry with a soft cloth. NEVER
USE ANY ABRASIVE PADS OR SCOURING POWDERS.
Completely dry grill before reinstalling. Refer to instructions
in Section 6
Completing the Installation , to reinstall grill.
2. Cleaning the Fan Assembly: Wipe all parts with a dry cloth
or gently vacuum the fan. NEVER IMMERSE ELECTRICAL
PARTS IN WATER.
CAUTION: ALLOW BULB TO COOL BEFORE REPLACING
3. Changing the Light Bulb: Disconnect power to the unit.
Remove grill by pulling downward on grill and squeezing grill
springs together to release from housing (Figure 14).
Incandescent Bulb (AK863L): Unscrew bulb from lamp
holder and replace with a 100 watt maximum, type A19
medium base incandescent bulb.
Fluorescent Lamp (AK863FL): Remove lamp by gently
rocking lamp back and forth while applying outward
pressure to release the lamp from the base. Replace with
a 26 watt maximum, 2 pin quad, G24-d3 fluorescent lamp.
Night Light (AK863L, AK863FL): Unscrew night light bulb
from socket and replace with a 7 watt maximum type C7
(candelabra base) night light bulb.
Sylvania model: CF26DD/841
GE model: F26DBXT4/SPX41
Phillips model: PL-C 26W/41/ALTO
Refer to instructions in Section 6
Finishing the Installation ,
to reinstall grill.
Figure 11
Figure 12
Flat Washer
Reflector
Lock Washers
Nut
Figure 13
Figure 14