Instructions

www.airkinglimited.com
6728002 Rev. F 1-11 3 of 12
4. Install an approved wire connector to the electrical knockout of the hood and
guide the electrical cable through the hood, allowing at least 6" of wire for
connections and tighten.
NOTE: If installing into existing construction and you will not have access to the
ductwork once the hood is in place, make ducting connections at this point. Refer to
the Ducting Section for instructions.
4. Install the 4 mounting screw at the previously marked locations. Leave
approximately 1/8" clearance. Slide the hood in place through the keyhole slots
and align the front of the hood so that it is flush with the front of the cabinets.
Tighten all screws securely (Figure 6).
SECTION 6
Wiring
CAUTION: ALL ELECTRICAL CONNECTIONS MUST BE MADE IN
ACCORDANCE WITH LOCAL CODES, ORDINANCES, OR NATIONAL ELECTRICAL CODE.
IF YOU ARE UNFAMILIAR WITH METHODS OF INSTALLING ELECTRICAL WIRING,
SECURE THE SERVICES OF A QUALIFIED ELECTRICIAN.
1. Connect the 2 loose White wires from the range hood to the White wire from the
supply, and the loose Black wire from the range hood to the Black wire of the
supply. Connect the ground wire (green or bare) from the supply to the green
ground screw of the hood. Use approved methods for all connections (Figure 7).
Figure 6
1/8"
Keyhole
NOTE: DO NOT disconnect any wiring that has already been crimped with a wire
connector from the factory.
2. Install the wire compartment cover and tighten screw. Make sure all wiring is
securely contained within the wire compartment.
SECTION 7
Ducting
CAUTION: ALL DUCTING MUST COMPLY WITH LOCAL AND NATIONAL
BUILDING CODES.
WARNING: TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
1. Connect the ducting to the hood’s duct collar and damper. Secure in place using
tape to seal all joints (Figure 8).
CAUTION: ALWAYS DUCT THE FAN TO THE OUTSIDE THROUGH A WALL
OR ROOF CAP.
SECTION 8
Finishing the Installation
1. Install the appropriate filter sliding the back side of the filter into the tab and
pressing the front of the filter into place (Figure 9).
2. Turn switches to the “OFF” position and restore power. Test that the light and the
fan are operating properly.
3. If there is any vibration noise, check for the source and try to tighten fasteners.
Figure 7
Neutral
(White)
from Light
Hot (Black)
Ground
(Green or Bare)
Neutral (White)
from Motor
Figure 9
Tab
Figure 5
Damper
Hood
Body
E-22A/RCD7
Figure 8