Installation Manual

CAUTION: FAILURE TO SECURE THE REFLECTOR BOLT
MAY RESULT IN A RATTLING OR HUMMING NOISE.
4. After the reflector bolt is secure, raise the grill/reflector up into position
and plug the reflector into the appropriate receptacle. Secure the
assembly to the reflector bolt using the acorn nut and lock washer.
Install the included 6 watt LED lamp into the lamp holder by lining up the
pins on the lamp base to the socket of the lamp holder and turning the
lamp body clockwise until the lamp snaps into place and is firmly seated
in the lamp holder (Figure 12).
5. Reinstall the lens into the grill.
6. Restore power and test your installation.
www.airkinglimited.com
6727919 Rev. C 4-17 4 of 12
SECTION 7
Use and Care
CAUTION: MAKE SURE POWER IS SWITCHED
OFF AT SERVICE PANEL BEFORE SERVICING THE UNIT.
CAUTION: ALLOW BULB TO COOL BEFORE REPLACING.
Changing the Lamp
Remove the light lens by squeezing at the tabs and pulling down (Figure
13). Remove lamp by gently twisting the lamp base counterclockwise while
applying outward pressure. Installation is the reverse of removal. Replace
with Air King model AK6LED40 or a compatible GU24 6 watt LED lamp.
Cleaning the Grill
Remove grill and use a mild detergent, such as dishwashing liquid, and
dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING
POWDERS. Completely dry grill before reinstalling. Refer to instructions in
Section 6 Finishing the Installation, to reinstall grill.
Cleaning the Fan Assembly
Unplug the motor cord from receptacle. Wipe all parts with a dry cloth or
gently vacuum the fan. NEVER IMMERSE ELECTRICAL PARTS IN WATER.
Plug the motor cord back in and restore power.
CALIFORNIA RESIDENTS ONLY:
WARNING: THIS PRODUCT CAN EXPOSE YOU TO
A CHEMICAL [OR CHEMICALS] KNOWN TO THE STATE OF
CALIFORNIA TO CAUSE CANCER.
WARNING: THIS PRODUCT CAN EXPOSE YOU TO
A CHEMICAL [OR CHEMICALS] KNOWN TO THE STATE OF
CALIFORNIA TO CAUSE REPRODUCTIVE TOXICITY.
Troubleshooting Guide
Trouble Probable Cause Suggested Remedy
1. Fan does not operate when the switch is on. 1a. A fuse may be blown or a circuit tripped. 1a. Replace fuse or reset circuit breaker.
1b. Connector plug from motor is not plugged in. 1b. Turn off power to unit. Remove Grill and plug motor into receptacle
in housing. Restore power to unit.
1c. Wiring is not connected properly. 1c. Turn off power to unit. Check that all wires are connected.
1d Motor has stopped operating. 1d. Replace motor.
2. Fan is operating, but air moves slower than normal. 2. Obstruction in the exhaust ducting. 2. Check for any obstructions in the ducting. The most common are bird
nests in the roof cap or wall cap where the fan exhausts to the outside.
3. Fan is operating louder than normal 3a. Motor is loose. 3a. Turn off power to unit. Remove grill and check that all screws are fully
tightened. Restore power to unit.
3b. Fan blade is hitting housing of unit. 3b. Call your dealer for service.
Tabs
Figure 13
Figure 12
Motor Clip
Mounting Bolt
Reflector
Grill
Lens
Tabs
Flange Nut
Figure 11
Nut