Installation Sheet

1b. Internal Wire Compartment: Using a 7/16" socket, remove the
two hex nuts holding the blower assembly in place. Lift up on the
assembly and slide it out of the tabs on the housing (Figure 6).
Remove the wire compartment cover screw and place the cover
in a secure place (Figure 7).
NOTE: If the fan motor plug is connected to the fan housing receptacle,
unplug so the blower assembly can be completely removed.
SINGE SPEED UNITS (models ES80S and ES130S)
2a. Run wiring from an approved wall switch (not included) carrying
the appropriate rating. One neutral (white), one ground (green or
bare copper), and one hot (black lead connected to the switch).
Secure the electrical wires to the housing with an approved
electrical connector. Make sure you leave enough wiring in the
box to make the connection to the fan’s receptacle.
2b. From where you have chosen to access the fan’s junction box,
connect the white wire from the house to the white wire from the
fan’s receptacle. Connect the black wire from the wall switch to
the black wire from the fan’s receptacle. Connect the ground wire
from the house to the green wire from the fan housing (Figure 8).
Use approved methods for all connections.
TWO SPEED UNITS (models ES80D and ES130D)
3a. Continuous Ventilation: For two speed fans wired for continuous
ventilation, connect the Black wire of the fan to the Black wire
(Hot) from the power source, connect the White wire of the fan
to the White (Neutral) wire from the power source. Connect the
ground wire from the house to the green wire from the fan housing.
Connect the two yellow wires from the fan to an approved wall toggle
switch (not included). Closing the switch will change from normal to
high speed (Figure 9).
www.airkinglimited.com
A210572218 New 7-09 3 of 12
3b. Intermittent Ventilation: For two speed fans wired for intermittent
ventilation with the recommended Air King model ESS2 switch
(not included), connect the Black wire (Hot) from the power source
to the 1C (common terminal) on the switch. Connect the Black wire
of the fan to the 1A terminal on the switch and connect a jumper
from the 1A to the 1b terminal. Connect the White (Neutral) wire
from the power source to the white wire on the fan. Connect
one of the two yellow wires from the fan to terminal 2C of the
switch. Connect the other yellow wire to terminal 2B of the
switch. Placing the toggle in the B position will energize high
speed placing the toggle in the center position will turn the
fan off and placing the toggle in the a position change the fan
to low speed. Connect the ground wire from the house to the
green wire from the fan housing (Figure 10).
NOTE: The fan’s receptacle wires might need to be pulled outside
compartment for connection. Only pull the five loose wires outside of
compartment. Additional wires will be present.
4. Carefully tuck wire back inside wire compartment and replace
wire compartment cover securing with the screw that was
removed earlier.
SECTION 5
Completing the Installation
1. If the fan’s blower assembly was removed during the wiring
process, reinstall the blower by reversing the directions in Section
4 (Wiring), Step 1b.
SINGE SPEED UNITS (models ES80S and ES130S)
2. Plug the fan’s 2 pin quick connect motor cord into the receptacle
located on the side of the wire compartment cover. Plug the 3 pin
Plug
Tabs
Hex Nuts
Figure 6
Figure 8
Supply from
house
Ground
White
Hot (Black)
Figure 9
Supply from
house
Ground
White
Hot (Black)
Yellow
Yellow
Switch
Figure 10
Supply from house
Ground
White
Hot (Black)
Yellow
Yellow
Switch
Fan
Figure 7
Screw
Wire Compartment
Cover