Instructions / Assembly

1b. Internal Wire Compartment: Using a 7/16" socket, remove the
two hex nuts holding the blower assembly in place. Lift up on the
assembly and slide it out of the tabs on the housing (Figure 6).
Remove the wire compartment cover screw and place the cover
in a secure place (Figure 7).
NOTE: If the fan motor plug is connected to the fan housing receptacle,
unplug so the blower assembly can be completely removed.
SINGLE SPEED UNITS (models ES80S and ES130S)
2a. Run wiring from an approved wall switch (not included) carrying
the appropriate rating. One neutral (white), one ground (green or
bare copper), and one hot (black lead connected to the switch).
Secure the electrical wires to the housing with an approved
electrical connector. Make sure you leave enough wiring in the
box to make the connection to the fan’s receptacle.
2b. From where you have chosen to access the fan’s junction box,
connect the white wire from the house to the white wire from the
fan’s receptacle. Connect the black wire from the wall switch to
the black wire from the fan’s receptacle. Connect the ground wire
from the house to the green wire from the fan housing (Figure 8).
Use approved methods for all connections.
TWO SPEED UNITS (models ES80D and ES130D)
3a. Continuous Ventilation: For two speed fans wired for continuous
ventilation, connect the White wire of the fan to the White (Neu-
tral) wire from the power source. Connect the ground wire from
the house to the green wire from the fan housing. Run 2 wires
from a properly grounded wall switch (not included) to the fan.
Connect the Black wire of the fan to the Black wire (Hot) from the
power source. Connect the Hot Yellow wire from the fan to the
input of the switch. Connect the second Yellow wire from the fan
to the output side of the switch. Closing the switch will change
from normal to high speed (Figure 9).
www.airkinglimited.com
A210572218 Rev. C 4-11 3 of 12
3b. Intermittent Ventilation: For two speed fans wired for intermittent
ventilation with a standard duplex toggle switch (such as Leviton
5224-2W not included). Connect the White wire of the fan to the
White (Neutral) wire from the power source. Connect the ground
wire from the fan to the ground wire from the power source.
Properly ground the switches. Connect the black wire from the
supply to one side of the top switch. Connect the black wire
from the fan to the other side of the top switch, Connect 1 yellow
wire from the fan to each side of the bottom switch. The top
switch turns the fan On & Off, the bottom switch changes speed
between high and low (Figure 10).
NOTE: The fan’s receptacle wires might need to be pulled outside
compartment for connection. Only pull the five loose wires outside of
compartment. Additional wires will be present.
NOTE: Unit must be grounded according to all local and national codes.
4. Carefully tuck wire back inside wire compartment and replace
wire compartment cover securing with the screw that was
removed earlier.
SECTION 6
Completing the Installation
1. If the fan’s blower assembly was removed during the wiring
process, reinstall the blower by reversing the directions in Section
4 (Wiring), Step 1b.
SINGE SPEED UNITS (models ES80S and ES130S)
2. Plug the fan’s 2 pin quick connect motor cord into the receptacle
located on the side of the wire compartment cover. Plug the 3 pin
Plug
Tabs
Hex Nuts
Figure 6
Figure 8
Supply from
house
Ground
White
Hot (Black)
Figure 7
Screw
Wire Compartment
Cover
Figure 9
Supply from
house
Hot (Black)
Black
Yellow
Yellow
Switch
Neutral
(White)
Ground (Green or Bare)
Figure 9
Supply from house
Hot
(Black)
Yellow
Black
Switch
Fan
Ground (Green or Bare)
Neutral (White)
Yellow