Use and Care Manual

ManualsBrandsAir King ManualsAppliancesDeluxe Quiet ENERGY STAR 36 in. 280 CFM Under Cabinet Ducted Range Hood with LED Light in Stainless Steel

IMPORTANT INSTRUCTIONS -

OPERATING MANUAL

SAVE THESE INSTRUCTIONS

www.airkinglimited.com

6728061 Rev. H 4-18 1 of 12

Range Hood

ECQ Series

WARNING: TO REDUCE THE RISK OF FIRE,

ELECTRIC SHOCK AND INJURY TO PERSON, OBSERVE THE

FOLLOWING:

a) Use this unit only in the manner intended by the manufacturer.If you have questions,

contact the manufacturer.

b) Before servicing or cleaning the unit, switch power off at service panel and lock the

service disconnecting means to prevent power from being switched on accidentally.

When the service disconnecting means cannot be locked, securely fasten a prominent

warning device, such as a tag, to the service panel.

WARNING: TO REDUCE THE RISK OF FIRE,

ELECTRIC SHOCK AND INJURY TO PERSON, OBSERVE THE

FOLLOWING:

a) Installation work and electrical wiring must be done by qualiﬁed person(s) in accordance

with all applicable codes and standards, including ﬁre-related construction.

b) Sufﬁcient air is needed for proper combustion and exhausting of gases through the

ﬂue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating

equipment manufacturer’s guideline and safety standards such as those published by

the National Fire Protection Association (NFPA) and the American Society for Heating,

Refrigeration, and Air Conditioning Engineers (ASHRAE), and the local code authorities.

c) When cutting or drilling into wall or ceiling, do not damage electrical wiring and other

hidden utilities.

CAUTION: FOR GENERAL VENTILATING USE ONLY. DO NOT

USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS AND VAPORS.

CAUTION: TO REDUCE THE RISK OF FIRE AND TO

PROPERLY EXHAUST AIR, BE SURE TO DUCT AIR OUTSIDE - DO NOT

VENT EXHAUST AIR INTO SPACES WITHIN WALLS OR CEILINGS OR INTO ATTICS, CRAWL

SPACES, OR GARAGES.

d) Ducted fans must always be vented to the outdoors.

e) This unit must be grounded.

f) To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall

spray, construction dust, etc. off power unit.

g) Read all instructions before installing or using range hood.

WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC

SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED

CONTROL DEVICE.

WARNING: TO REDUCE THE RISK OF A RANGE TOP

GREASE FIRE:

a) Never leave surface units unattended at high settings. Boil overs cause smoking

and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.

b) Always turn hood ON when cooking at high heat or when ﬂambéing food (ie. Crepes

Suzette, Cherries Jubilee, Peppercorn Beef Flambé).

c) Clean ventilating fans frequently. Grease should not be allowed to accumulate on

fan ﬁlter.

d) Use proper pan size. Always use cookware appropriate for the size of the surface

element.

WARNING: TO REDUCE THE RISK OF INJURY TO PERSONS

IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE

FOLLOWING:

a) SMOTHER FLAMES with a close-ﬁtting lid, cookie sheet, or metal tray, then turn off

burner. BE CAREFUL TO PREVENT BURNS. If the ﬂames do not go out immediately,

EVACUATE AND CALL THE FIRE DEPARTMENT.

b) NEVER PICK UP A FLAMING PAN - You may be burned.

c) DO NOT USE WATER, including wet dishcloths or towels -

a violent steam explosion will result.

d) Use an extinguisher ONLY if:

I. You know you have a Class ABC extinguisher, and you already know how to

operate it.

II. The ﬁre is small and contained in the area where it started.

III. The ﬁre department is being called.

IV. You can ﬁght the ﬁre with your back to an exit.

WARNING: TO REDUCE THE RISK OF FIRE, USE ONLY

METAL DUCTWORK.

WARNING: THE DUCTING FROM THIS FAN TO THE OUTSIDE OF

THE BUILDING HAS A STRONG EFFECT ON THE AIR FLOW, NOISE AND ENERGY

USE OF THE FAN. USE THE SHORTEST, STRAIGHTEST DUCT ROUTING POSSIBLE FOR

BEST PERFORMANCE, AND AVOID INSTALLING THE FAN WITH SMALLER DUCTS THAN

RECOMMENDED. INSULATION AROUND THE DUCTS CAN REDUCE ENERGY LOSS AND

INHIBIT MOLD GROWTH. FANS INSTALLED WITH EXISTING DUCTS MAY NOT ACHIEVE

THEIR RATED AIRFLOW.

READ AND SAVE THESE INSTRUCTIONS

READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN

THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY

INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY

AND/OR PROPERTY DAMAGE!

RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.

GENERAL SAFETY INFORMATION

When using electrical appliances, basic precautions should always

be followed to reduce the risk of ﬁre, electric shock and injury to

person, including the following:

Summary of content (12 pages)

PAGE 1
IMPORTANT INSTRUCTIONS OPERATING MANUAL ECQ Series Range Hood READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
PAGE 2
INSTALLATION INSTRUCTIONS CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE STARTING INSTALLATION. 2. The thickness of the strips should be the same as the recess of the cabinet and they should be approximately 2" wide. 3. Install the strips using appropriate length wood screws (not included). Make sure the strips line up to the keyhole slots of the range hood. SECTION 1 SECTION 3 1. 1.
PAGE 3
SECTION 4 WARNING: TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK. Installing the Range Hood CAUTION: MAKE SURE POWER IS SWITCHED OFF AT 1. SERVICE PANEL BEFORE STARTING INSTALLATION. NOTE: If installing into existing construction and you will not have access to the ductwork once the hood is in place, make ducting connections at this point. Refer to the Ducting Section for instructions. 1. Connect the ducting to the hood’s duct collar.
PAGE 4
SECTION 9 Changing the Lamp 1. Controls Your Range Hood is equipped with two rotary switches with one controlling the lighting and the other controlling the exhaust fan. The light switch has three positions, Main Light ( ● ), Night Light ( ◗ ), and OFF ( ■ ). The fan switch has three positions, High, Low, and OFF. LED Lamp: Remove lamp by gently twisting counterclockwise to release the lamp from the base. Installation is the reverse of removal.
PAGE 5
LIMITED WARRANTY WHAT THIS WARRANTY COVERS: This product is warranted against defects in workmanship and/or materials. HOW LONG THIS WARRANTY LASTS: This warranty extends only to the original purchaser of the product and lasts for one (1) year from the date of original purchase or until the original purchaser of the product sells or transfers the product, whichever first occurs.
PAGE 6
REPLACEMENT PARTS DIAGRAM 2 4 1 16 14 15 19 6 3 18 5 8 10 7 17 9 # 1 2 Qty. 1 1 11 3 1 12 4 5 11 13 6 7 8 9 10 11 12 13 14 15 16 17 18 19 6728061 Rev. H 4-18 2 1 www.airkinglimited.
PAGE 7
INSTRUCCIONES IMPORTANTES – MANUAL DE OPERACIÓN Séries ECQ Hotte de cuisinière LIRE ET CONSERVER CES INSTRUCTIONS LIRE SOIGNEUSEMENT AVANT DE TENTER D’ASSEMBLER, INSTALLER, OPÉRER OU DE RÉPARER LE PRODUIT DÉCRIT. PROTÉGEZ VOUS-MÊME ET LES AUTRES EN OBSERVANT TOUTE L’INFORMATION DE SÉCURITÉ. FAILLIR À SE CONFORMER AUX INSTRUCTIONS PEUT RÉSULTER EN BLESSURE PERSONNELLE GRAVE ET/OU EN DOMMAGE À LA PROPRIÉTÉ. CONSERVER CES INSTRUCTIONS POUR RÉFÉRENCES FUTURES.
PAGE 8
INSTRUCTIONS POUR L’INSTALLATION MISE EN GARDE : ASSUREZ-VOUS QUE 2. L’épaisseur des bandes doit correspondre au retrait de l'armoire et doit avoir une largeur d'environ 5 cm. 3. Posez les bandes à l’aide de vis à bois (non comprises) de longueur appropriée. Assurez-vous que les bandes sont alignées aux encoches en trou de serrure de la hotte. SECTION 1 SECTION 3 L’ALIMENTATION ÉLECTRIQUE EST COUPÉE À PARTIR DU PANNEAU DE DISTRIBUTION AVANT DE COMMENCER L’INSTALLATION.
PAGE 9
SECTION 4 AVERTISSEMENT : AFIN DE RÉDUIRE LES RISQUES D’INCENDIE, UTILISEZ UNIQUEMENT DES CONDUITS EN MÉTAL. Installation de la hotte 1. MISE EN GARDE : ASSUREZ-VOUS QUE L’ALIMENTATION ÉLECTRIQUE EST COUPÉE À PARTIR DU PANNEAU DE DISTRIBUTION AVANT DE COMMENCER L’INSTALLATION. REMARQUE : si vous installez la hotte dans une construction existante et que vous n'aurez plus accès aux conduits une fois la hotte fixée, posez-les maintenant.
PAGE 10
5. Si vous entendez un bruit de vibration, cherchez-en la source et essayez de resserrer les fixations. Sinon, vous pouvez ajuster le ruban adhésif afin de resserrer ou de sceller le point de connexion. SECTION 9 Fusible 1. Pour remplacer la fusible, tournez vers la droite le dessus de la fusible localisée à coté du fil conducteur et tirez. Remplacez avec une fusible de 125 volts, 1-1/2 ampères max. Remettez la fusible dans son emplacement.
PAGE 11
GARANTIE LIMITÉE QUE COUVRE CETTE GARANTIE : Ce produit est garanti contre tout vice de fabrication ou de matière. COMBIEN DE TEMPS CETTE GARANTIE DURE : Cette garantie se rapporte seulement à l’acheteur original du produit et dure pendant une (1) année de la date de l’achat original ou jusqu’à ce que l’acheteur original du produit vend ou transfère le produit, celui qui se produit en premier.
PAGE 12
TABLEAU DES PIÈCES DE RECHANGE 2 4 1 16 14 15 19 6 3 18 5 8 10 7 17 9 11 12 11 13 # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 6728061 Rev. H 4-18 www.airkinglimited.com Qté.