user manual

INDUSTRIAL CEILING FAN
1. Follow the recommended instructions for the
proper method of wiring your ceiling fan. If you
do not know enough about electrical wiring, have
your fan installed by a licensed electrician.
2. All wiring must satisfy National and Local electrical
codes. The ceiling fan must be grounded as a
precaution against possible electrical shock.
3. The electrical outlet box and joist must be securely
mounted and capable of reliably supporting at
least 50 pounds.
4. WARNING: To reduce the risk of fire, electrical
shock and/or personal injury:
a) Be sure electricity is turned off at the main fuse
box before wiring, cleaning or servicing.
b) Fan should not be mounted in areas where it
might become wet
1. Be careful of the fan and moving blades when
cleaning, painting or working near fan.
2. Do not put anything into the blades while they
are turning.
3. Do not bend the blade brackets when installing
the brackets, balancing the blades or cleaning the
fan.
4. WARNING: The fan must be hung with at least 7
feet of clearance from floor to blades.
READ AND SAVE THESE INSTRUCTIONS
RULES FOR SAFE OPERATION
1. Unscrew the speed control cover and screw
base onto wall.
2. Connect the switch white wire to the black
(Hot) supply wire using a listed wire nut.
Connect the switch black wire to the black
(Hot) lead wire from the fan using a listed wire
nut. (Figure 7)
WALL SWITCH WIRING
1. Insert one screw through the lockewasher and
into the motor hub. Do not tighten fully at this
time. (Figure 8)
2. Install the second screw in the same manner,
then tighten both screws fully.
3. Repeat steps 1 and 2 for the 2 remaining blades.
ATTACHING FAN BLADES
Figure 7
Wall
Switch
Black
Supply
(Hot)
Black lead
from fan
(Hot)
White Supply
(Neutral)
3. Replace the front cover of the switch control
box with the supplied screws and tighten.
Figure 8
Blade
Screw &
lockwasher
INSTRUCTION MANUAL
Models: 9848, 9856 & 9860
MAINTENANCE
Periodic cleaning of your ceiling fan is the only
maintenance that is needed. When cleaning, use only
a soft brush or lint free cloth to avoid scratching the
finish. Abrasive cleaning agents are not required and
should be avoided to prevent damage to the finish.
Do not use water when cleaning your ceiling fan. It
could damage the motor or the blades and create
the possibility of an electrical shock or fire.
WARRANTY
The ceiling fan you have purchased is warranted by
the manufacturer for one year from the date of
purchase against defects in workmanship and/or
materials. The motor is warranted for ten years. This
warranty means that only the parts that prove to be
defective during the period of warranty will be either
repaired or replaced at our option. The right is
reserved by the manufacturer to replace the whole
product in lieu thereof. Should repair become
necessary during the warranty period, write to: AIR
KING c/o LASKO PRODUCTS, INC., Appliance Service
Department, 820 Lincoln Ave., West Chester, PA
19380. Describe the problem you are having. DO NOT
SEND FAN!
This warranty does not apply if the damage occurs
because of accident, improper handling, installation
or operation, shipping damage, abuse, misuse or
unauthorized repairs made or attempted. ALL
WARRANTIES, EXPRESSED OR IMPLIED LAST FOR ONE
YEAR FROM DATE OF ORIGINAL PURCHASE, EXCEPT
FOR THE MOTOR. THIS WARRANTY DOES NOT COVER
LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES FOR ANY CAUSE WHATSOEVER. Some
states do not allow limitations on how long any
implied warranty lasts, or the exclusion or limitations
of incidental or consequential damages, so that the
above limitation or exclusion may not apply to you.
This warranty gives you specific legal rights, and you
may have other rights that vary from state to state.
FOR REPLACEMENT PARTS: Please call 1-800-966-
2028, Monday - Friday, between the hours of 8am
and 4 pm EST. Reference the type and style of product
when you call.
FOR QUESTIONS OR COMMENTS ABOUT YOUR
CEILING FAN: Please call 1-800-233-0268, Monday -
Friday, between the hours of 8am and 4pm EST.
New 7/00