Instructions / Assembly
SECTION 9
Operation
Controls
Your Range Hood is equipped with two rotary switches with one controlling the lighting
and the other controlling the exhaust fan. The light switch has three positions, HIGH ( ● ),
LOW ( ◗ ), and OFF ( ■ ). The fan switch is an infinite speed control that can be adjusted
to your desired setting. Rotating the switch counter clockwise until you hear a click will
turn the hood off.
SECTION 10
Maintenance
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL
BEFORE SERVICING THE UNIT.
Filters
Grease Filter - Included with your range hood is an aluminum grease filter that should
be washed in hot water with detergent once a month. Reverse the instructions in the
“Finishing the Installation” section of the instructions to remove filter. If the grease filter
becomes damaged, replace with Air King Model GF-06S Grease Filter.
Charcoal Odor Filter - If you have installed an optional combination grease/charcoal
filter, it cannot be washed and must be discarded and replaced when it becomes
noticeably dirty, has stopped filtering the odors, or at least once per year. Replace with
Air King Model CF-06S Combination Odor/Grease Filter.
www.airkinglimited.com
6728005 Rev. C 8-12 4 of 12
Troubleshooting Guide
Trouble Probable Cause Suggested Remedy
1. Hood does not operate when the switch is on. 1a. A fuse may be blown or a circuit tripped. 1a. Replace fuse or reset circuit breaker.
1b. Wiring is not connected properly. 1b. Turn off power to unit. Check that all wires are connected.
2. Hood is operating, but air moves slower than normal. 2. Obstruction in the exhaust ducting. 2. Check for any obstructions in the ducting including filter.
3. Hood is making a rattling noise. 3a. Filters are loose. 3a. Turn off power to unit. Check that all filter are securely in place.
3b. Duct connection is loose. 3b. Turn off power to unit. Check that duct connection is tight.
Cleaning
CAUTION: DO NOT USE GASOLINE, BENZINE, THINNER, HARSH
CLEANSERS, ETC., AS THEY MAY DAMAGE THE RANGE HOOD.
1. Clean your range hood with a mild detergent, such as dishwashing liquid, and
dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS.
Completely dry before restoring power. NEVER IMMERSE ELECTRICAL PARTS IN
WATER.
2. The fan assembly can be vacuumed when build up (dirt, lint, etc.) accumulates over
time. The fan is permanently lubricated and does not require oiling.