6728005 Rev. D 11-12 3 of 12
4. Install an approved wire connector to the electrical knockout of the hood and guide the
electrical cable through the hood, allowing at least 6" of wire for connections and tighten.
NOTE: If installing into existing construction and you will not have access to the ductwork
once the hood is in place, make ducting connections at this point. Refer to the Ducting Section
5. Install the 4 mounting screws at the previously marked locations. Leave approximately 1/8"
clearance. Slide the hood in place through the keyhole slots and align the front of the hood
so that it is ﬂush with the front of the cabinets. Tighten all screws securely (Figure 6).
CAUTION: DO NOT INSTALL CLOSER THAN 22 INCHES ABOVE COOKING SURFACE.
CAUTION: ALL ELECTRICAL CONNECTIONS MUST BE MADE IN ACCORDANCE
WITH LOCAL CODES, ORDINANCES, OR NATIONAL ELECTRICAL CODE. IF YOU ARE
UNFAMILIAR WITH METHODS OF INSTALLING ELECTRICAL WIRING, SECURE THE
SERVICES OF A QUALIFIED ELECTRICIAN.
1. Connect the 2 loose White wires from the range hood to the White wire from the supply,
and the loose Black wire from the range hood to the Black wire of the supply. Connect
the ground wire (green or bare) from the supply to the green ground screw of the hood.
Use approved methods for all connections (Figure 7).
NOTE: DO NOT disconnect any wiring that has already been crimped with a wire connector
from the factory.
2. Install the wire compartment cover and tighten screw. Make sure all wiring is securely
contained within the wire compartment.
CAUTION: ALL DUCTING MUST COMPLY WITH LOCAL AND NATIONAL
WARNING: TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
1. Connect the ducting to the hood’s duct collar and damper. Secure in place using tape to
seal all joints (Figure 8).
CAUTION: ALWAYS DUCT THE FAN TO THE OUTSIDE THROUGH A WALL OR
Finishing the Installation
1. Install the ﬁlter by ﬁtting the ﬁlter into the channel on the hood and sliding it back until it
stops against the back of the hood (Figure 9).
2. Turn switches to the “OFF” position and restore power. Test that the light and the fan are
3. If there is any vibration noise, check for the source and try to tighten fasteners.
Your Range Hood is equipped with two rotary switches with one controlling the lighting and the
other controlling the exhaust fan. The light switch has three positions, HIGH ( ● ), LOW ( ◗ ),
and OFF ( ■ ). The fan switch is an inﬁnite speed control that can be adjusted to your desired
setting. Rotating the switch counter clockwise until you hear a click will turn the hood off.
(Green or Bare)