User's Manual

11
Technical Support
1-800-248-0892
Ext. 2
GUIDE rolling lobe top studs through
holes in upper mounting bracket
while lowering frame. Attach
with hardware shown.
Driver-Side View
½" Nut
¾" Jam Nut
Lock Washer
Air Fitting
Small
Stud
Large
Stud
Inside of Beam
GUIDE rolling lobe bottom stud through
hole in center of beam. Attach with
hardware shown.
½" Nut
Lock
Washer
Beam
Raise or lower axle to create
12.5"
between mounting brackets.
Installing the RoadTamer System
Installing the Rolling Lobe Air Sleeves
Figure 14
Refer to Figure 14 for the following instructions.
1. Install the fi tting into the large top stud of the rolling
lobe air sleeve. Tighten the fi tting fi nger-tight plus
1
1
/2 turns, being careful to tighten on the metal hex
nut only.
NOTE: It may be necessary to raise the chassis
to provide adequate space to install the rolling
lobe air sleeves.
2. Insert the bottom studs of both rolling lobe air sleeves
into the lower mounting hole of the beam assemblies
on both sides of the vehicle. Attach fi nger-tight using
a ½” lock washer and nut.
3. Lower the frame while guiding both top studs on
the rolling lobe air sleeves through the holes in the
upper mounting bracket.
4. Attach the air sleeves using a ¾” jam nut on the large
stud. Use a lock washer and ½” nut on the smaller
stud. Tighten the top mounts securely. Leave the
bottom loose at this time.