User's Manual

13
Technical Support
1-800-248-0892
Ext. 2
Installing the RoadTamer System
Reattaching the Brake Cables
1. Reattach the passenger side emergency brake cable
to the top of the rear end using the new hanger
supplied and the stock rear end cover bolt. Tighten
securely (Figure 18).
Figure 18
Figure 19
Final Adjustments
2. Reattach the driver side brake line to the shock
bracket using the existing hardware. Attach the
driver-side emergency brake cable to the inside,
rear U-bolt using the double tube clamp and the
supplied 5/8” - 18 jam nut (Figure 19).
Figure 20
Driver-Side Shown
Keep a distance of 12 - 13
inches for operation of vehicle.
12 - 13 inches
New Supplied Brake
Cable Bracket
Stock Bolt
1. Infl ate both rolling lobe air sleeves to 20 p.s.i and
check for leaks.
2. Tighten both bottom rolling lobe mounts securely
at this time. Torque to 50 ft/lbs.
3. An Air Lift SmartAir system must be installed with this
kit. Follow the instructions in the SmartAir manual
to install the system. Once the SmartAir system is
installed it will automatically maintain the rolling lobe
air springs’ installed height of 12 - 13 inches within
their mounts (Figure 20).
4. Routing the exhaust out of the side of the vehicle
in front of the rear wheel on the passenger side is
recommended.
NOTE: It may be necessary to have a custom-bent
pipe made if routing the exhaust out the back
behind the rear wheels is desired.
5. IMPORTANT: Check and re-torque all mounting
hardware, especially the beam U-bolts, after 150
miles and every 10,000 miles.