Installation Manual

10
MN-520
NOTE
g. 12
Both tabs go down
g. 13
INSTALLING THE HEAT SHIELD (ON V10 TRITON MODELS)
V10 Triton models with shock heat shield: If the vehicle is a late model that has a V10
Triton engine with a shock heat shield which was removed in the “Getting Started” section,
bend the tabs on the replacement shock heat shield (P) and attach to the shock using the
clamps provided (Fig. 12). Fold the replacement shock heat shield (P) around the shock and
bend the top tabs so they overlap (Fig. 13)
LoadLifter 5000
g. 11
TIPS FOR INSTALLING AIR LINES
When cutting air lines, use a sharp knife or a hose
cutter and make clean, square cuts (Fig. 11). Do not
use scissors or wire cutters because these tools may
deform the air line, causing it to leak around fittings.
Do not cut the lines at an angle.
Do not bend the 1/4” hose at a radius of less than 1” or
bend the 3/8” hose at a radius of less than 1 1/2”. Do
not put side load pressure on fitting. The hose should be
straight beyond the fitting for 1” before bending.
Inspect hose for scratches that run lengthwise on hose
prior to installation. Contact Air Lift customer service at
[phone] if the air line is damaged.
Go to air-lift.co/cuttingairline to watch a
video demonstrating proper air line cutting.