User`s manual

AirLive WL-5460AP v2 User Manual
44
Ø Band: You can choose one mode of the following you need.
¤ 2.4GHz (B): 802.11b supported rate only.
¤ 2.4GHz (G): 802.11g supported rate only.
¤ 2.4GHz (B+G): 802.11b supported rate and 802.11g supported rate.
The default is 2.4GHz (B+G) mode.
Ø Site Survey: Site survey helps to find out available access point around. You can also
check to prevent using same SSID or channel with other AP.
Ø SSID (Network ID): The SSID differentiates one WLAN from another; therefore, all
access points and all devices attempting to connect to a specific WLAN must use the
same SSID. It is case-sensitive and must not exceed 32 characters. A device will not
be permitted to join the BSS unless it can provide the unique SSID. An SSID is also
referred to as a network name because essentially it is a name that identifies a
wireless network.
In this mode, the SSID is provided for client connection.
Ø Channel Number: Allow user to set the channel manually or automatically. If set
channel manually, just select the channel you want to specify. If “Auto” is selected,
user can set the channel range to have Wireless Access Point automatically survey
and choose the channel with best situation for communication. The number of
channels supported depends on the region of this Access Point. All stations
communicating with the Access Point must use the same channel.
Ø Wireless Client Isolation: This is to separate wireless client if needed. Wireless
clients can not communicate to each other if the field is enabled.
Ø Site Survey: Site survey helps to find out available access point around. You can also
check to prevent using same SSID or channel with other AP.
Ø WAN Port (LAN2): WL-5460AP provides 4 methods for client to access the internet.
This depends on the location and the service which the ISP provides. You need to
contact the ISP for detail information.