User`s manual

4. Appendix
AirLive WN-220ARM User’s Manual 65
4.1 Troubleshooting
4
4. 4.Appendix
Q: Why can’t I configure the router even the cable is plugged and the LED is
lit?
A:
Do a Ping test to make sure that the WN-220ARM is responding.
Go to Start > Run.
1. Type cmd.
2. Press OK.
3. Type ipconfig to get the IP of default gateway.
4. Type “ping 192.168.1.254”. Assure that you ping the correct IP Address
assigned to the WiFi Broadband Router. It will show four replies if you
ping correctly.
Ensure that your Ethernet Adapter is working, and that all network drivers are
installed properly. Network adapter names will vary depending on your