SDS

D0301281
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
6. Accidental release measures
Environmental precautions
Personal precautions, protective equipment and emergency procedures
Stop leak if without risk. Move containers from spill area. Approach release from
upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash
spillages into an effluent treatment plant or proceed as follows. Contain and collect
spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or
diatomaceous earth and place in container for disposal according to local regulations
(see Section 13). Dispose of via a licensed waste disposal contractor. Contaminated
absorbent material may pose the same hazard as the spilled product. Note: see
Section 1 for emergency contact information and Section 13 for waste disposal.
:
:
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. In the case of aerosols being ruptured, care should be taken due to the rapid
escape of the pressurized contents and propellant. If a large number of containers are
ruptured, treat as a bulk material spillage according to the instructions in the clean-up
section. Do not touch or walk through spilled material. Avoid breathing vapor or mist.
Provide adequate ventilation. Wear appropriate respirator when ventilation is
inadequate. Put on appropriate personal protective equipment.
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
:
Stop leak if without risk. Move containers from spill area. Dilute with water and mop up
if water-soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and
place in an appropriate waste disposal container. Dispose of via a licensed waste
disposal contractor.
:
Methods and materials for containment and cleaning up
:
If specialised clothing is required to deal with the spillage, take note of any information
in Section 8 on suitable and unsuitable materials. See also the information in "For non-
emergency personnel".
7. Handling and storage
Conditions for safe storage,
including any
incompatibilities
Do not store above the following temperature: 50°C (122°F). Store in accordance with
local regulations. Store away from direct sunlight in a dry, cool and well-ventilated area,
away from incompatible materials (see Section 10) and food and drink. Protect from
sunlight. Use appropriate containment to avoid environmental contamination.
:
Put on appropriate personal protective equipment (see Section 8). Pressurized
container: protect from sunlight and do not expose to temperatures exceeding 50°C. Do
not pierce or burn, even after use. Do not ingest. Avoid contact with eyes, skin and
clothing. Avoid breathing gas. Avoid breathing vapor or mist. Use only with adequate
ventilation. Wear appropriate respirator when ventilation is inadequate. Empty
containers retain product residue and can be hazardous.
:
Precautions for safe handling
4/12
15/12/2015.
Date of issue
:
SDS #
FF0299265_2
:
Code #
D0301281
: