MSDS

D8187186
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
8. Exposure controls/personal protection
Citral
ACGIH TLV (United States, 6/2013).
Absorbed through skin. Skin sensitizer.
TWA: 5 ppm 8 hours. Form: Inhalable
fraction and vapor
Hand protection
Use a properly fitted, air-purifying or air-fed respirator complying with an approved
standard if a risk assessment indicates this is necessary. Respirator selection must be
based on known or anticipated exposure levels, the hazards of the product and the safe
working limits of the selected respirator.
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary. Considering the parameters specified by the glove manufacturer, check
during use that the gloves are still retaining their protective properties. It should be
noted that the time to breakthrough for any glove material may be different for different
glove manufacturers. In the case of mixtures, consisting of several substances, the
protection time of the gloves cannot be accurately estimated.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: chemical splash goggles.
Eye/face protection
Respiratory protection
:
:
:
Body protection
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before handling
this product.
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure they
comply with the requirements of environmental protection legislation. In some cases,
fume scrubbers, filters or engineering modifications to the process equipment will be
necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
Good general ventilation should be sufficient to control worker exposure to airborne
contaminants.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period. Appropriate
techniques should be used to remove potentially contaminated clothing. Contaminated
work clothing should not be allowed out of the workplace. Wash contaminated clothing
before reusing. Ensure that eyewash stations and safety showers are close to the
workstation location.
Hygiene measures
:
Individual protection measures
Skin protection
Other skin protection
:
Appropriate footwear and any additional skin protection measures should be selected
based on the task being performed and the risks involved and should be approved by a
specialist before handling this product.
9. Physical and chemical properties
Physical state
Melting point
Liquid.
Not available.
Not available.
Odor
pH
Not available.
Color
Not available.
Not available.
Odor threshold
:
:
:
:
:
:
Appearance
6/14
01/12/2014.
Date of issue
:
SDS #
FF0077124_6
:
Code #
D8187186
: