User's Manual

Configure DEV2:

1. Access the web server (http://192.168.2.254) of device from the Ethernet port.

Caution

If you configure multiple devices in the same PC, since the devices

have the same default IP address but different MAC addresses, it may

cause you not able to access the web server of device. If the situation

happens, please try to clean the ARP table of your PC by DOS

command “arp –d” then you can access the web server of device

using the default IP address.

2. Use Wizard page to setup device.

3. Press “Next>>” button then set the “Operation Mode” to “Bridge” mode.

4. Press “Next>>” button then disable “Time Zone” function.

5. Press “Next>>” button then set the IP address of LAN interface.