User's Manual

Ch 1. AP-G200 Installation
Packing List
Before you start to install the device, make sure the package contains the following
items：
z AP-G200 High Power Multi-Mode AP
z PoE Power Injector
AP-G200 PoE Power Injector
Hardware Installation
Once you check off everything from the package, you can start to install the device.
You can use the wall mount hole on the bottom of the device to mount the device on
the wall, or just put the device on the desktop. The administrator can refer to the figure
below while constructing your WLAN environment.
Connect Two Ethernet Patch Cables As Follows:
2
1) Data In: connects to your router or other network uplink
2) P+Data Out: connects to AP-G200 (this provides both
the Ethernet + 48VDC power to the unit)