User Guide

Thank you for purchasing the Airaid Intake System. Contact Airaid @ [phone] 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions
that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are
missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION
IS THE DRIVERS RESPONSIBILITY! The air filter is reusable and should be cleaned periodically.
13. Install the four 1/4” Button Head Screws , and four
Flat Washers into the Airaid Intake Tube from inside the
Cold Air Box.
10. Extend the Primary Mass Air Flow sensor’s wire
harness.
11. Set the Airaid Cold Air Box in the inner fender area
as shown.
12. Slide the Intake Tube down and into the Cold Air
Box, then into the Hump Hose on the turbo inlet.
18. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Double check the
hood clearance!
Reconnect the negative battery cable!
REV.03.14.17
14. Secure the Cold Air Box to the inner fender using
three of the OEM bolts removed in step 4.
15. Tighten the two Hump Hose Clamps. On the turbo
inlet.
16. Reconnect the Mass Air Flow sensors. Note: the
Extension Harness is to be routed underneath the Intake
Tube.
17. Install the Airaid Premium Filter onto the Intake Tube
inside of the Cold Air Box. Install the Weather Strip onto
the top edge of the Cold Air Box with the contour rolling
away from the filter. Reinstall the fender trim and brace.
1
2
WARNING! If your vehicle has a Vehicle Emission Control Information decal affixed to the factory airbox, a new replacement label must be obtained and installed
in a readily visible position in the engine compartment in order to remain CARB compliant. Failure to do so will prevent the vehicle from passing a smog check. Replacement
labels can be ordered from your local dealership. Regulations state that the VECI label shall not be affixed to any equipment which is easily detached from the vehicle. Label
placement, under the hood on a painted surface is recommended.
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
FILTER IDENTIFICATION
720-472 Airaid Oiled Media 721-472 Airaid SynthaMax Dry Media - Red
722-472 Airaid SynthaMax Dry Media - Black 723-472 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil. Service
air filter as needed by cleaning with common non-
petroleum all-purpose household cleaner and wa-
ter. Simple Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of air filter
and allow to soak. Then flush filter clean from
the inside out with a garden hose and repeat steps
if necessary. Do not apply high pressure water or
air to clean filter. Allow filter to air dry and rein-
stall.
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Airaid. 1815 West Crest Lane. Phoenix AZ 85027 [phone] [e-mail] www.airaid.com
INTAKE SYSTEMS FOR VEHICLES LISTED ARE 50 STATE
LEGAL. SEE AIRAID.COM FOR CARB STATUS ON EACH
PART FOR A SPECFIC VEHICLE.
AIR-I20295C