Owners manual

# 200-586 INSTALLATION INSTRUCTIONS

02-09 Chevrolet TrailBlazer/GMC Envoy 4.2L

2003-08 Isuzu Ascender 4.2L

2005-08 Saab 9-7X 4.2L

Parts List

AIR-KIT586PA Aluminum Plate (1)

AIR-KIT586H Hardware

“O” Ring (1)

6mm x 60mm Bolts (4)

6mm Flat Washers (4)

Extension Plates (2)

6mm x 25mm Flat Head Screws (2)

Tools List

10mm Socket

4mm Socket (stud removal)

5/32” Allen Wrench

Also available, the Airaid Intake System, p/n

200-126-1 for the 2002-05 Chevrolet/GMC

models.

Thank you for purchasing the PowerAid Throttle Body Spacer. Please read the

instruction manual carefully before proceeding with the installation. Your PowerAid

Throttle Body Spacer was carefully inspected and packaged. Check that no parts are

missing, or were damaged during shipping. If you need any assistance please call 1-

800-858-3333 to speak with a representative in our Customer Service Center before

returning the product.

Thank you for selecting AIRAID.

Included with your Poweraid Spacer is a sticker with a California Air Resources Board

(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of

the engine compartment. Failure to do so may prevent you from passing a smog inspection.

INTAKE SYSTEMS FOR VEHICLES LISTED ARE 50 STATE

LEGAL. SEE AIRAID.COM FOR CARB STATUS ON EACH

PART FOR A SPECFIC VEHICLE.

PAGE 1
# 200-586 INSTALLATION INSTRUCTIONS 02-09 Chevrolet TrailBlazer/GMC Envoy 4.2L 2003-08 Isuzu Ascender 4.2L 2005-08 Saab 9-7X 4.2L Thank you for purchasing the PowerAid Throttle Body Spacer. Please read the instruction manual carefully before proceeding with the installation. Your PowerAid Throttle Body Spacer was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping.
PAGE 2
Installation Instructions. Read Me! 1. DISCONNECT NEGATIVE (-) BATTERY CABLE. 2. Remove throttle body air intake system. 3. Remove (4) nuts & studs from the throttle body and manifold. (Ref. “C”) 4. Install power plate using (4) 6mm x 60mm bolts and (4) 6mm flat washers. (Ref. “C”) * Please Note: The engraved side of plate faces the throttle body 5. Install (2) extension plates using (2) 6mm flat head screws. (Ref. “D”) 6.