Owners manual

350-532 INSTALLATION INSTRUCTIONS

2005-16 Dodge Challenger/Charger, Magnum &

Chrysler 300 5.7L V8

2005-09 SRT-8 6.1L V8

2006-09 Jeep Grand Cherokee SRT-8 6.1L V8

2011-15 Dodge Challenger/Charger & Chrysler 300

SRT-8 6.4L V8

For 2010 6.1L SRT-8 motors use Pn 350-635

Tool List

8mm Socket

10mm Socket

Ratchet

Parts List

AIR-KIT532PA Aluminum Plate (1)

AIR-KIT532H Hardware

“O” Ring (1)

6mm x 60mm Bolts (4)

6mm Flat Washers (4)

51mm Screws (Black) (4)

Also available for your Dodge Magnum, Challenger,

Chrysler 300C , Dodge Charger, or Jeep Cherokee,

the Airaid Intake System. Call for Details!

Thank you for purchasing the PowerAid Throttle Body Spacer. Please read the

instruction manual carefully before proceeding with the installation. Your PowerAid

Throttle Body Spacer was carefully inspected and packaged. Check that no parts are

missing, or were damaged during shipping. If you need any assistance please call 1-

800-858-3333 to speak with a representative in our Customer Service Center before

returning the product.

Thank you for selecting AIRAID.

INTAKE SYSTEMS FOR VEHICLES LISTED ARE 50 STATE

LEGAL. SEE AIRAID.COM FOR CARB STATUS ON EACH

PART FOR A SPECFIC VEHICLE.

PAGE 1
350-532 INSTALLATION INSTRUCTIONS 2005-16 Dodge Challenger/Charger, Magnum & Chrysler 300 5.7L V8 2005-09 SRT-8 6.1L V8 2006-09 Jeep Grand Cherokee SRT-8 6.1L V8 2011-15 Dodge Challenger/Charger & Chrysler 300 SRT-8 6.4L V8 For 2010 6.1L SRT-8 motors use Pn 350-635 Thank you for purchasing the PowerAid Throttle Body Spacer. Please read the instruction manual carefully before proceeding with the installation. Your PowerAid Throttle Body Spacer was carefully inspected and packaged.
PAGE 2
Installation Instructions. Read Me! 1. DISCONNECT NEGATIVE (-) BATTERY CABLE. 2. Remove air intake assembly. 3. Remove the original (4) bolts from the throttle body. 4. For vehicles with Aluminum Manifolds: Install power plate using supplied (4) 6mm x 60mm bolts and (4) 6mm flat washers. 5. For vehicles with composite manifolds: Use (4) 51mm Black Screws (Ref. “B”) (The 51mm black screws are not compatible with metal threaded intake manifolds.) 6.