Owners manual

# 400-590 INSTALLATION INSTRUCTIONS

97-03 Ford F-150/97-04 Expedition 4.6L

Parts List

AIR-KIT590PA Aluminum Plate (1)

AIR-KIT590G Gasket (2)

AIR-KIT590H Hardware

Linkage Plates (3)

6mm x 16mm Flat Head Screws (3)

6mm x 50mm Bolts (4)

6mm Washers (4)

Tools List

10mm Socket

5/32 Hex Key

Standard Screwdriver

Also available for your F-150/Expedition,

the AirAid Intake System p/n 400-109. Call

For Details!

Thank you for purchasing the PowerAid Throttle Body Spacer. Please read the

instruction manual carefully before proceeding with the installation. Your PowerAid

Throttle Body Spacer was carefully inspected and packaged. Check that no parts are

missing, or were damaged during shipping. If you need any assistance please call 1-

800-858-3333 to speak with a representative in our Customer Service Center before

returning the product.

Thank you for selecting AIRAID.

Included with your Poweraid Spacer is a sticker with a California Air Resources Board

(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of

the engine compartment. Failure to do so may prevent you from passing a smog inspection.

INTAKE SYSTEMS FOR VEHICLES LISTED ARE 50 STATE

LEGAL. SEE AIRAID.COM FOR CARB STATUS ON EACH

PART FOR A SPECFIC VEHICLE.

PAGE 1
# 400-590 INSTALLATION INSTRUCTIONS 97-03 Ford F-150/97-04 Expedition 4.6L Thank you for purchasing the PowerAid Throttle Body Spacer. Please read the instruction manual carefully before proceeding with the installation. Your PowerAid Throttle Body Spacer was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If you need any assistance please call 1800-858-3333 to speak with a representative in our Customer Service Center before returning the product.
PAGE 2
Installation Instructions. Read Me! 1. DISCONNECT NEGATIVE (-) BATTERY CABLE. 2. Remove throttle body intake assembly. 3. Remove (2) bolts & save from linkage bracket. (Ref. “C”) 4. Remove (4) bolts from throttle body. (Ref. “D”) 5. Remove gasket and clean surfaces. 6. Install power plate with (2) gaskets. (Ref. “A”) A. Place one gasket between the thr ottle body and power plate. B. Place second gasket between the power plate and manifold. 7. Replace (4) 6mm x 50mm bolts (Ref.