Owners manual

1. Disconnect the negative battery cable!

Using a 5/16” socket, loosen two hose clamps that

hold the intake tube between the throttle body, and the

air cleaner lid.

Turn the green tab, and disconnect the breather hose

from the air intake tube. Remove the intake tube from

the vehicle.

2. Using a 5/16” socket, remove the 4 bolts that hold

the throttle body to the intake manifold.

Thank you for purchasing the PowerAid Throttle Body Spacer. Please read the in-

struction manual carefully before proceeding with the installation. Your PowerAid Throttle

Body Spacer was carefully inspected and packaged. Check that no parts are missing, or

were damaged during shipping. If you need any assistance please call 1-800-858-3333 to

speak with a representative in our Customer Service Center before returning the product.

Thank you for selecting AIRAID.

Parts List

AIR-KIT613PA Aluminum Plate (1)

AIR-KIT613G Gasket (1)

AIR-KIT633H Hardware

6mmx65mm Bolts (4)

6mm Flat Washers (4)

Tools Required For Installation

5/16”, 10mm Sockets

Ratchet and Extension

Installation Instructions

Part Number 450-613

Poweraid Spacer For

2005-10 Ford Mustang

4.0L V-6

Included with your Poweraid Spacer is a sticker with a California Air Resources Board

(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of

the engine compartment. Failure to do so may prevent you from passing a smog inspection.

INTAKE SYSTEMS FOR VEHICLES LISTED ARE 50 STATE

LEGAL. SEE AIRAID.COM FOR CARB STATUS ON EACH

PART FOR A SPECFIC VEHICLE.

PAGE 1
Installation Instructions Part Number 450-613 Poweraid Spacer For 2005-10 Ford Mustang 4.0L V-6 Parts List AIR-KIT613PA Aluminum Plate AIR-KIT613G Gasket AIR-KIT633H Hardware 6mmx65mm Bolts 6mm Flat Washers (1) (1) (4) (4) Tools Required For Installation 5/16”, 10mm Sockets Ratchet and Extension INTAKE SYSTEMS FOR VEHICLES LISTED ARE 50 STATE LEGAL. SEE AIRAID.COM FOR CARB STATUS ON EACH PART FOR A SPECFIC VEHICLE. Included with your Poweraid Spacer is a sticker with a California Air Resources Board (C.
PAGE 2
Spacer Gasket Bolts & Washers 3. Install two bolts (#2), and washers (#3) thru the throttle body, thru the gasket (#4), thru the Poweraid Spacer (#1), and into the intake manifold as shown. Use caution to retain the factory o-ring gasket on the plastic intake manifold. Next install the remaining bolts in the bottom holes of the throttle body, and tighten evenly to the manufacture's specifications. Do Not Over Tighten The Bolts! 4. Reinstall the intake tube, and tighten the hose clamps.