Install Guide

- 15 -
4. Set the appropriate elevation angle and tighten the bolts so that the angle is
locked in place. The bracket design allows for up to 20
° tilt of the antenna.
5. Secure both the cable between the external antenna and the outdoor unit, and
the Category 5E cable between the outdoor unit and the indoor unit to the mast
using UV-rated tie-wraps (4 are included). Note: It is recommended that you
secure the entire cable length to the mast every 10 feet.
6. Repeat steps one through five for the second outdoor unit in the remote
location.
7. If necessary, use the AI108 antenna alignment tool to fine tune your received
signal strength (RSS). Loosen the pole mounting clamps and elevation control
bolts again, and rotate the antenna slowly around its mast. As the antenna
slews towards the remote device, the RSS indicator will show an increase. Keep
rotating the unit until the maximum strength signal has been obtained, then
tighten all fasteners and bolts to secure the assembly.
8. Repeat step seven for the second external antenna.