User Manual

Airaya
- 13 -
Airaya
Proven, Fast and Affordable Outdoor Wireless Bridges
Follow these steps to install the indoor injector unit:
1. Connect the To Network port on the indoor injector unit to your
1000/100 Mbps Ethernet switch or router using a straight-through
Category 5 UTP cable.
2. Connect the power brick to the 48 VDC In power socket on the indoor
injector unit and then plug the power brick into the wall power
receptacle. Warning: Use only the power adapter supplied with the
WirelessGRID-300 bridge in order to prevent damage.
3. You are now ready to apply power to the outdoor unit. Connect the 48V
OUT + Signal port to the outdoor unit using the included (black)
Category 5e cable attached to the outdoor unit. The 48V OUT LED will
light to indicate that the indoor injector unit is active and outputting 48
volts, .4 amps to the 48V OUT + Signal port.
TIP
After applying power to the outdoor unit, the link light on your network
connection (Switch or Router Port) should be on.