User Manual

Airaya
- 35 -
Airaya
Proven, Fast and Affordable Outdoor Wireless Bridges
If you receive ping responses from both test stations, the network IP configuration and
physical wiring is working properly between the 2 test stations using Ethernet. If you
cannot ping both test stations, check your Ethernet cable connections and test station
network settings to verify they are configured properly.
When ping works properly with wired test stations, go to Step 2.
Step 2. Setup wired Ethernet network connections to bridges
Connect directly using straight-thru cables, or through network switches or routers using
straight-thru Ethernet cables.
Example IP Configuration of test stations and outdoor bridges with default
configuration parameters:
1. Start a continuous ping from test Station A to bridge end point A. To start a
continuous ping using the factory default IP settings of the bridge, type the
following into a DOS or CMD window on test station A:
NOTE
WirelessGRID products shipped as complete kits have one bridge factory-configured with IP address 192.168.1.70, and one
bridge factory-configured with IP address 192.168.1.71. Both bridges have a default subnet mask of 255.255.255.0
1000 Mbps full duplex (gigabit) ports are best from connecting bridges to wired Ethernet networks.
NOTE
If ping does not work between 2 wired test stations, it will not work between 2 test stations connected by a WirelessGRID link.