User Manual

AirBedz
®
Original Truck Bed Air Mattresses are warranted against defects in material and
workmanship for a period of one year from the date of purchase. Problems covered by the
warranty include failure of the pump, seams or the valve. Punctures or wear to the mattress due
to use or abuse are not covered. It is normal for an airbed that has been inflated for extended
periods to require the addition of air after a few days. Air will be lost from the mattress through
the material over time. Also, cooling of the air around the bed will cause the air inside the bed to
contract, and the bed will be softer and may need refilling. To receive a replacement air mattress
under Pittman Products International’s One-Year Warranty, you will need to:
• All returns must have a Returned Goods Authorization number (RGA). Every package
must be clearly marked with the RGA number. RGA numbers are good for 30 days
from the date of issuance. Products returned without viewable RGA numbers will be
refused. No returns on special order, clearance or discounted items. Returned
products is subject to a 20% Re-Box/Restocking fee. Products must be properly
packed to prevent shipping damage. All returned product must be shipped pre-paid.
The cost of transporting the product to Pittman Outdoors for warranty service/
replacement is the responsibility of the purchaser.
• Send entire product to Pittman Products International with a letter stating:
- The nature of the problem with the bed and the model number.
- Your name, return shipping address and a daytime phone number.
• Send us a copy of the original sales receipt.
• This warranty is valid for the original retail purchaser from the date of the initial
retail purchase and is not transferable.
The purchase date on the receipt must be within One Year of the date you ship the bed to us.
Please ship the bed, letter and copy of receipt via courier (e.g. UPS, FedEx Ground) or Insured
Post to:
Pittman Products International
Attn: Returns
15330 Valley View Ave, Suite 2
La Mirada, California 90638
Pittman Products International is not responsible for returned shipments lost in transit. You
are encouraged to use a shipment system that offers you a tracking number. Please allow 6
to 8 weeks for replacement. Customer is responsible for all return shipping costs.
WARRANTY DISCLAIMER
6 3
DEFLATION
NOTE: DEFLATE AIR MATTRESS SLIGHTLY BEFORE REMOVING FROM TRUCK BED TO AVOID
SNAGGING OR TEARING MATTRESS ON TRUCK BED. IT IS BETTER TO FULLY DEFLATE MATTRESS
IN PLACE TO AVOID DAMAGE.
1. Pull middle valve (B) from bladder valve (C).
2. Fold bed according to Folding Instructions below and place into carrying bag and
store until next use.
Two Stage Valve
SET UP GUIDE (cont.)
INFLATION
1. Place your bed in the back of truck bed or on a flat surface free of debris,
obstructions and sharp objects.
2. Spread the mattress out so that it can fill easily. Allowing the mattress to "unfold"
itself may place an unnecessary strain on the mattress and the pump.
3. Plug the AirBedz
®
portable pump into your vehicles cigarette lighter or accessory
power jack.
4. Locate proper pump adapter fitting and insert into middle valve (B).
5. Turn pump on and inflate to desired firmness.
To increase pump pressure and to decrease inflate time, please ensure your
vehicle's engine is turned on. This will allow the pump to operate at maximum
voltage (14.4V vs 12V).
6. Remove pump and push valve cap (A) into middle valve (B) firmly.
7. Unplug pump when not in use.
* For faster inflates, you may insert pump directly into bladder valve (C) until the mattress is about 90% full. Then insert
middle valve (B) into bladder valve (C) and continue to fill until desired firmness is reached.