Use and Care Manual

FOR HELP, CALL 1.800.547.3888 OR VISIT AIRCAREPRODUCTS.COM

Model 836000HB (analog controls with digital display screen)

Turn On and Set Controls

1. Press the fan/power knob once to turn the unit on. Two dashes (--) will

appear on the display.

2. Rotate the fan knob

clockwise to set the fan

level. The fan speed proceeds from low (F1) to high

(F3). NOTE: The knob will rotate freely clockwise.

To decrease the fan speed, turn the knob counter-

clockwise.

3. Rotate the humidity knob

clockwise to set the

percentage of desired humidity. The range for set-

ting the humidity is from 25% to 65%, and goes up

in 5% increments. Lower the level by rotating the

humidity knob counterclockwise.

OPERATION:

Model 831000 (full digital controls)

Turn On and Set Controls

1. Press the power button once to turn unit on.

Two dashes (--) will appear on the display.

2. Adjust the fan speed by pressing the fan

button . The display will show the fan

speed as it proceeds from low (F1) to high (F3).

3. Press the humidity button to set the percent-

age of desired humidity. The range for setting the

humidity is from 25% to 65% and goes up in 5%

increments as the button is pressed. Once 65% is

reached,

the cycle starts over again at 25%.

Humidifier Status Indications

Refill Indication: When the reservoir is empty, an F displays on the LCD scree

Check Filter: After every 720 hours of operation a reminder to check the

filter/wick condition is programmed to show CF on the display. Check the

condition of the filter/wick, and change it if necessary.

Clear the CF display

by unplugging the humidiﬁer, waiting 60 seconds, and plugging it back in.

Control Lock: You can lock the controls to avoid unwanted changes to

your settings by pressing and holding the power button down for ﬁve

seconds. CL will display for a few seconds, then resume displaying room

humidity. Turn o this feature by holding down the power button for ﬁve

seconds.

Common to All Models