Specifications

Ibis 3 Owners Guide Revision V1 Page 15 of 19
Plenum Status Display (Figure 26)
In addition to the remote control there is a status display on the corner of the inside plenum.
This row of lights indicates the mode that the air conditioner is operating in.
The MANUAL OPERATION BUTTON can be used to access basic functions without the remote.
Figure 26 - Status display in corner of inside plenum
OPERATION USING REMOTE CONTROL
SET CLOCK ON REMOTE
 Press CLOCK (Figure 25– Button #6) Clock
icon will flash on display.
 Use Temperature UP / DOWN (Figure 25–
Button #11 & 12) to change time.
 When time is correctly displayed press SET
(Figure 25 – Button #7)
SET TIMER ON AND TIMER OFF – Note you
must complete SET CLOCK first
 Press TIMER ON (Figure 25 – Button #4)
 Temperature UP / DOWN to change time
 When time is correctly displayed press SET
(Figure 25– Button #7)
 Repeat above process with TIMER OFF
(Figure 25– Button #5)
COOLING MODE
 Turn unit ON (Figure 25– Button #1) (Figure
17)
 Press MODE (Figure 25– Button #2) until
COOL is displayed in the Mode Display
(Figure 20)
 Press FAN SPEED (Figure 25 – Button #10)
until the required speed is selected (Figure
19)
 Press TEMPERATURE UP / DOWN for your
required set point temperature. (Figure 21)
DRY MODE
 Turn unit ON
 Press MODE until DRY is displayed in the
Mode Display
 Press TEMPERATURE UP / DOWN for your
required set point temperature.
FAN MODE
 Turn unit ON
 Press MODE until FAN is displayed in the
Mode Display
 Press FAN SPEED until the required speed is
selected
HEATING MODE
 Turn unit ON
 Press MODE until HEAT is displayed in the
Mode Display
 Press FAN SPEED until the required speed is
selected
 Press TEMPERATURE UP / DOWN for your
required set point temperature.
AUTO MODE
 Turn unit ON
 Press MODE until AUTO is displayed in the
Mode Display
 Press FAN SPEED until the required speed is
selected
 Press TEMPERATURE UP / DOWN for your
required set point temperature.
Mode indicator lights
A coloured LED illuminates above
mode that the unit is operating in.
Example shown – Cool
Fault Indication
Operation faults are indicated
by a number of rapid flashes of
the FAN LED
Refer to trouble shooting guide
& contact Aircommand for
service advice.
Manual operation button
On occasion when the remote
has been lost or is not working it
is possible to access basic
functions with this button.
Press to cycle through
ON / COOL / FAN / HEAT / OFF