Specifications

8
SECTION
Coast
to Coast
CARAV
AN & LEISURE
950-02700
This zinc-plated element wrench goes
where other wrenches can’t, allowing you
to remove and replace screw-in elements
with ease. It works in conjunction with
your screwdriver and fits all 5” regular
screw-in elements and 1-1/2” nuts.
Available as either a gas or gas/
electric model, the Truma Boiler
features 12V remote electronic
ignition & a food grade stainless
steel hot water tank. It is light &
operates quietly, providing heated
water quickly. Easy to
install & operate it comes with
a 1yr Dometic warranty.
Capacity: 14Lt
Dimensions (mm): 350L x 350W x 320H
Weight (empty): 6.7Kg
Gas Consumption: 120g/hr
Electric Heating Element: 240V AC (~850W)
950-09102
An electric hot water system with
high quality insulation, thus making
it energy efficient thanks to its
minimal heat loss. The Electroboiler
comes with a 1 year manufacturer’s
warranty from Dometic.
Capacity: 14Lt
Weight: 3Kg (dry)
Dimensions: 405L x 405W x 295H (mm)
Water Pressure: 2.8bar (max)
Current Consumption: 3.7A (on 240V)
Warm up time: 70mins approx. (based on full tank with water
starting at 15
0
C and heating to 70
0
C)
950-09000
Truma 14Lt Hot Water Service - Gas Only
950-09010
Truma 14Lt Hot Water Service - Gas & Electric
CAMCO SCREW-IN ELEMENT WRENCH 5”
FOR SUBURBAN HWS
TRUMA BOILER B14 HOT WATER SYSTEM
DOMETIC ELECTROBOILER
What if I operate the water heater without water in the
tank?
Operation without water in the tank on the 12V DC gas portion
of the water heater can cause the copolymer insulation jacket
to melt & can cause the ECO/Thermostat to trip. Operation
without water in the tank on the 230V AC electric portion of the
water heater will damage the element.
There is a bad odour coming from the hot water faucet.
How can I correct this?
Odour from the hot water system is not a service problem & many
water supplies contain sufficient amounts of sulphur to produce
an odour. The odour is similar to rotten eggs & is often referred
to as “sulphur water.” Sulphur water is not harmful - only
unpleasant to smell. Sulphur water can be caused by a chemical
action or by bacteria. The key to eliminating this smell is heavy
chlorination of the water system. Add about six (6) ounces of
chlorine (common household liquid bleach) to each 10 gallons in
the water tank. Then run the heavily chlorinated water throughout
the system, opening each faucet one at a time until you smell
the chlorine. Let the RV sit a few days & the chlorine should
take care of the problem. Then you will need to take care of the
chlorine by flushing the water system. If you don’t have a water
filtration system that removes chlorine, you may have a problem
getting rid of the chlorine taste. You might consider adding such a
system because it allows you to keep water chlorinated and this
prevents several problems, including sulphur water. Chlorination
also takes care of other types of bacteria & viruses.
How do I drain my water heater?
Follow the steps below:
1. Turn off electrical power to the water heater either at the
switch from the electric element or a breaker.
2. Shut off the gas supply to the water heater.
3. Turn off the pressure pump on the water system.
4. Open both hot & cold water faucets.
5. Remove the anode rod from the tank. (NOTE: TAKE CARE
as water may be HOT when drained from the unit).
6. Follow the RV manufacturer’s instructions for draining
the entire water system.
193
950-02710
Replace temperature
& pressure valves faster
and more safely. The Valve
Remover gives you better access
to the water heater housing,
reducing injuries. Fits Atwood and
Suburban (Mor-Flo) water heaters
CAMCO T & P UNIVERSAL VALVE REMOVER