Installation Manual

PureFlow AirDog®

AirDog® FP-100 & FP-150 1998.5-2004 Cummins Diesel

Section 6-B Fuel lines (Supply Line 2003-2004 with CP3)

Installing the Fuel Supply Line from the AirDog® to the CP3

Injection Pump 2003-2004

When installing the AirDog

fuel system, it is recommended to bypass the factory filter

canister for optimum engine performance.

6B-1. Using a 17mm wrench, remove the “banjo bolt” (Highlighted in Figure 23) and the

original factory fuel supply line at the fuel inlet port of the CP-3 high pressure pump.

6B-2. Install the 12mm x 1/2” male SAE J2044 (WAP 102) fitting with the seal washer (1P-5-

DS) supplied into the inlet port of the CP3 injection pump (Figure 24) once the original

fitting is removed. Do not over tighten the fitting. It may crack or break. Either remove

or bend the original supply line out of the way.

6B-3. Refer to steps 6A-3 and 6A-4 to install the fuel supply line for the CP3.

WAP102

1P-5-DS

Figure 23

Figure 24