Installation Manual

PureFlow AirDog®
AirDog® FP-100 & FP-150 1998.5-2004 Cummins Diesel
Section 6-E (Continued) Fuel lines (Suction Line from Tank FP-150)
20
6E-4. Drill a 1-1/8” hole at the selected location (Figure 42) in the fuel tank for the suction
tube. Hold a container below the drill point to catch debris as shown in figure 43.
6E-5. Remove all burrs from the edge of the hole as shown in figure 44.
6E-6. Install the grommet (P/N 5J-1-1-04-0001) in the new suction tube access hole as seen in
figure 45.
6E-7. Measure and cut the suction tube to a length that will allow approximately 1/8”
clearance off the bottom of the tank. It is suggested to form the end of the tube similar
to Figure 46.
Figure 43
Figure 42
Figure 44
Figure 45
Figure 46