Installation Manual

PureFlow AirDog®
AirDog® FP-100 & FP-150 2005 and Up Cummins Diesel
Section 4 (Continued) Fittings, Brackets, and Mounting
10
4-3. Attach the AirDog® to the frame bracket assembly as shown in figure 6 using the
supplied hardware in the mounting bracket hardware kit (P/N 901-61-0102-PM). You
will need a 3/16” Allen and a 7/16” wrench.
NOTE: We recommend installing the AirDog® on the inside of the frame rail, but we understand
some applications just don’t have the room. The photos in this manual may not be the same as
your application.
4-4. Be sure to tuck the AirDog® as far up as possible without it rubbing on anything to
prevent damage from road debris. The bracket assembly is adjustible to achieve this.
4-5. Clamp the frame between the AirDog® bracket assembly and the backing plate using the
3/8” x 3 ½” bolts, lock washers, and nuts included in the kit. Use two 9/16” wrenches to
tighten.
Mount
The AirDog®
Outside
The
frame
OR
Inside
The
Frame
4-6. Position the AirDog® on the frame as necessary for clearance. Properly torque the bolts
& nuts!
Figure 6
Figure 10
Figure 9
Figure 8
Figure 7
Inside of Frame
Outside of Frame