Installation Manual

PureFlow AirDog®
AirDog® FP-100 & FP-150 2005 and Up Cummins Diesel
Section 6-D (Continued) Fuel lines (Suction Line from Tank)
19
6D-4. Drill a 1-1/8” hole at the selected location (Figure 38) in the fuel tank for the suction
tube. Hold a container below the drill point to catch debris as shown in figure 39.
6D-5. Remove all burrs from the edge of the hole as shown in figure 40.
6D-6. Install the grommet (P/N 5J-1-1-04-0001) in the new suction tube access hole as seen in
figure 41.
6D-7. Measure and cut the suction tube to a length that will allow approximately 1/8”
clearance off the bottom of the tank. It is suggested to form the end of the tube similar
to Figure 42.
Figure 39
Figure 38
Figure 40
Figure 41
Figure 42