Installation Manual

PureFlow AirDog®

AirDog® FP-100 & FP-150 2005 and Up Cummins Diesel

Section 7 (Continued) Wiring Harness

Connecting the AirDog® Power Lead Jumpers

7-2. Remove the factory wire harness connection from the top of the fuel module as seen in

(Figure 49)

7-3. Plug the AirDog® female power lead jumper into the top of the fuel module.

7-4. After a “click” is heard, slide the red locking clip over to lock the connection in place.

7-5. Plug the factory wire harness connector into the AirDog male power lead jumper. Again,

listen for the “click”.

Connecting the Power Supply Leads to the Alternator or Battery

Note: Connecting the power supply leads to the alternator instead of the battery will create a

corrosion resistant connection.

7-6A. Route the Red and Black power supply leads to the alternator. Connect the Black (-) lead

to the alternator Chassis Ground connection. Connect the Red (+) lead to the alternator

Hot Lead going to the battery.

Figure 49

Black (-)

Red (+)

Replace the Protective Cover

Figure 50

Figure 51