User Manual

8
Assembling the Fuel Lines
This kit includes a length of fuel line and separate fuel line ends to allow for
much cleaner looking installations! Assemble the fuel lines as you install them.
You won’t want to pre-assemble the hoses or your lengths may be off.
1. Take the fuel line end and lubricate the barbed end with clean motor oil (Figure 2) and
press it into the fuel line (HS02) until all three barbs are covered (Figures 3 and 4). The
fuel line end should look like Figure 4.
2. Now plug that fuel line with that fitting into the connection on the either the Raptor or
the truck where the manual calls it out.
3. Run the fuel line away from any hot or moving parts such as exhaust or the driveshaft.
Cut the hose to length and insert the other fuel line end that the manual calls out into
the fuel line as outlined in step 1.
NOTE: Hose clamps are not needed for these push-lock connectors.
Figure 2
Figure 4
Figure 3