User Manual

INSTALLING THE FRRP-100

1. Replace the 2 original sealing washers on the stock banjo fitting with the 2 new ones

provided (part# 1P-5-DS). And firmly tighten the factory fuel supply line in the inlet port

of the FRRP using the factory banjo fitting. The factory support bracket is no longer

used.

2. Install the 08J2044-3/4UNF fitting in the port labeled “Out,” using a 7/8" Wrench.

Reference Figure 5.

4. Firmly tighten the FRRP to the stock bracket using the hardware supplied. See Fig 6

5. Install the 12mm X ½” Male SAE J2044 Quick Connect Fitting (part# WAP102) with

seal washer supplied into the inlet port on the fuel filter canister. Do not over tighten.

The fitting could crack or break! See Figures 7 & 8.

1998.5 - 1999 2000 - 2002

Figure 7 Figure 8

Note: Figures 7 & 8 depict a push lock style connection. This kit is supplied with connects as

shown in the parts list.

Figure 6

Figure 5